Here’s a step-by-step guide on how to safely and effectively use the American Red Light Therapy Bed M4N at home, along with tips for maximizing results:
1. Pre-Session Preparation
Clean Your Skin: Remove makeup, lotions, or oils to ensure light penetrates fully.
Hydrate: Drink water before/after sessions to support detoxification.
Clothing: Wear minimal clothing (e.g., shorts/sports bra) or expose skin directly for best results.
Eye Protection: Use provided goggles (NIR can penetrate eyelids).
2. Step-by-Step Usage
Step 1: Power On
Plug in the bed and turn it on using the control panel.
Select your desired wavelength (options may include 660nm red, 850nm NIR, or combined).
Step 2: Set Session Time
Beginner: Start with 5–10 minutes (gradually increase to 15–20 mins).
Advanced: Up to 20 mins per session (max 1–2x/day).
Step 3: Position Yourself
Lie down flat inside the bed, ensuring your body is aligned with the LED panels.
For full-body coverage, rotate halfway through the session (if the bed is single-sided).
Step 4: Start the Session
Relax and breathe normally. The bed will automatically shut off when time elapses.
3. Post-Session Care
- Moisturize: Apply aloe vera or hyaluronic acid to enhance skin benefits.
- Hydrate Again: Water helps flush toxins released during therapy.
- Consistency: Use 3–5x/week for optimal results (chronic issues may require 4–6 weeks).
4. Recommended Protocols
| Goal | Wavelength | Time/Session | Frequency |
|---|---|---|---|
| Anti-Aging | 660nm red | 10–15 mins | 3–5x/week |
| Muscle Recovery | 850nm NIR | 15–20 mins | Daily (post-workout) |
| Joint Pain | 660nm + 850nm combo | 15 mins | 5x/week |
| Overall Wellness | Combo | 10–20 mins | 3–4x/week |
5. Safety Tips
- Avoid Overuse: More than 20 mins/session may cause skin dryness or fatigue.
- Contraindications: Do not use if pregnant, photosensitive, or with active cancer.
- EMF Exposure: Choose beds with low EMF emissions (M4N is typically safe).
6. Troubleshooting
- “No Power”: Check connections and ensure the outlet works.
- “LEDs Not Lighting”: Confirm wavelength settings are selected.
- Skin Redness: Reduce session time or increase distance from LEDs.
7. Maximizing Results
- Pair with exercise: Use post-workout to boost recovery.
- Combine with skincare: Apply vitamin C serum after RLT for collagen synergy.
- Track progress: Take before/after photos for skin or pain improvements.
Pro Tip: For deep-tissue pain, use the 850nm NIR setting and target areas within 6 inches of the LEDs. Consistency is key—results typically show after 4–6 weeks.